IndianEngineer

ProjectsectsBazaar.in

Remote controlled appliance switch circuit

Remote controlled appliance switch circuit

 

Description.

Here is a versatile remote controlled appliance switch that can ON or OFF any appliance connected to it using a TV remote.

 

IR remote sensor IC TSOP 1738 is used for recieving the signal. Normally when no signal is falling on IC3 the output of it will be high.This makes Q1 OFF.When a signal of 38 KHz from the TV remote falls on the IC3 its output goes low.This makes Q1 conduct and a negative pulse is obtained at pin 2 of IC 1  NE 555.Due to this IC1 wired as a monostable multivibrator produces a 4 Sec  long high signal at its out put.This high out put is the clock for IC 2 which is wired as a Flipflop and of , its two outputs pin 3 goes low and pin 2 goes high.The high output at pin 2 is amplified to drive the relay .For the next signal  the outputs of IC2 toggles state. Result, we get a relay toggling on each press on the remote.Any appliance connected to this circuit can be switched ON or OFF.

Circuit Diagram with Parts List .

remote-appliance-switch-circuit_ct.jpg

Notes.

  • Before wiring the circuit make sure that the carrier frequency  of the TV remote you have is 38 KHz.For that wire the sensor part only ,point your remote to the TSOP1738 and press any switch.If  out put of TSOP1738  goes  low them ok, your remote is of 38Khz type.Nothing to worry almost all TV remote are of this type.
  • You can use any switch because for any switch the code only changes,the carrier frequency remains same.We need this carrier frequency only.
  • Assemble the circuit on a good quality PCB or common board.
  • The appliance can be connected through NO or NC  and contacts of the relay .

www.indianengineer.wordpress.com

email   freshersblog@gmail.com

Go to contact us page to contact Us or leave us an email.

We Deals in Projects Kits,circuits,models,presentations,training kits,

 Wanna Buy this projects call Us. 9717408885

Low cost projects only at indianEngineer’s

Advertisements

October 5, 2009 - Posted by | circuit, project ideas | , , , , , , , , ,

3 Comments »

  1. i join to your website

    Comment by shyam | May 5, 2010

  2. i join

    Comment by shyam | May 5, 2010

  3. Thanks for spending time on the computer (wnrgiit) so others don’t have to.

    Comment by Yelhsa | January 2, 2015


Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: